Installation Sheet

1. UPPER CROSS BRACE
2. LOWER CROSS BRACE
1
2
INSTALLATION
2. PRE-DRILL PILOT HOLES
Using a 1/4” drill bit, pre-drill holes in
the upper and lower cross braces
inside the cabinet as determined in
previous step. Ensure that the holes in
both braces are drilled to the same
measurement.
1. PREPARE CABINET
Screws will be drilled through the
upper and lower cross braces inside
the cabinet. Determine location of
screws, ensuring that the location of the
mounting screw is as close to the center
of the cabinet as possible.
Example shown
with studs & unit to
illustrate mounting.
Partially insert a #14 x 4” screw
in the upper cross brace.
4. PARTIALLY INSERT SCREW
3. LOCATE & MARK STUD
Using a stud nder, locate stud in
wall and mark the wall according
to the pre-drilled holes in cabinet.
Setting cabinet aside, pre-drill holes
in stud using a 1/4” drill bit. Do not
attempt to mount only by hard
board of cabinet.
5. INSTALL UNIT
Begin installation by carefully lifting
unit into position. Then, attach the
cabinet to the wall by fully inserting
the screw in the upper cross brace
into the wall stud.
Make sure the unit is plumb and
level. Shim if necessary. Fully tighten
installation screw.