Installation Sheet

7. INSTALL UNIT
Begin installation by carefully lifting unit
into position. Then attach the cabinet
to the wall by fully inserting the screw in
the upper cross brace into the wall stud.
Make sure the unit is plumb and
level. Shim if necessary. Fully tighten
installation screw.
8. INSERT SECOND SCREW
Insert the second #14 x 4” screw into
the pre-drilled hole in the bottom brace
of the cabinet and attach to wall
making sure cabinet remains square
and level.
12. INSTALLATION COMPLETE
Cabinet is now fully installed!
11. ADD TRIM
Add decorative trim or molding to
make cabinet sides ush with the face
frame.
6. INSTALL ELECTRICAL WIRING
Verify that there is ample supply wire
available to run from the top of the
ironing center to the approximate
location of electrical pigtails.
Note: A free wire length of 48” is
recommended.
Begin to place the ironing center into
its location while feeding the supply
wire through electrical knockout, and
the 3/8” romex connector through the
back of the raceway.
9. CONNECT WIRES
Connect all power supply wires and
ground wires in accordance with
electrical codes. Trim supply wire as
necessary.
10. REPLACE ELECTRICAL RACEWAY
Place the raceway cover into
position, ensuring that no wires
are pinched. Reinstall the top and
bottom screw to secure in place.