Installation Sheet

Surface Mount Installation
2. PRE-DRILL HOLES
Using a 1/4” drill bit, pre-drill holes in
the upper and lower cross braces
inside the cabinet as determined in
previous step. Ensure that the holes
in both braces are drilled to the
same measurement.
1. PREPARE CABINET
Screws will be drilled through the upper
and lower cross braces (see pg. 11)
inside the cabinet. Determine location
of screws, ensuring that the location of
the mounting screw is as close to the
center of the cabinet as possible.
Partially insert one #14 x 4”
screw in the upper cross brace.
4. PARTIALLY INSERT SCREW
3. LOCATE & MARK STUD
Using a stud nder, locate desired
stud in wall and mark the wall
according to the pre-drilled holes in
cabinet. Setting cabinet aside,
pre-drill holes in stud using a 1/4” drill
bit. Do not attempt to mount only
through hardboard of cabinet.
Example shown
with studs & unit to
illustrate mounting.
5. REMOVE ELECTRICAL KNOCKOUT
Open the front cover of the raceway
by removing the screw at the top
and bottom of the raceway.
Locate the electrical knockout, as
specied on diagram provided.
Install a 3/8” romex connector where
the knockout was removed.
Position of Electrical Knockout for
SURFACE MOUNT ONLY
24
1/2
”
2
13/16
”