E 42 Specification Packet

RECESSED CLEARANCE - BOARD EXTENDED
Minimum required space for the ironing board to lower
completely and swivel without hitting an obstacle.
RECESSED
MOUNT
SURFACE
MOUNT
1. Clearance from Wall to
Tip of Board
42” 46”
2. Hinge Side Clearance for
180º Degree Door Swing
16” 16”
Swivel Clearance Requirements
For Further Review
1. Space required for board to come down flat
To ensure a flat and level ironing surface, be sure to that
you have a full 42” in front of the desired installation
location when recessing. When surface mounting, ensure
there is 46” clearance.
2. Recommended 16” on hinge side for full 180º
door swing
While not required, we recommend 16” on hinge side to
allow the door to open fully against the wall, ensuring
optimal standing area when ironing.
Items to Note:
Page 2 of 3 Page 3 of 3
Installation Types
Recessed
Placed into the wall, between 16” on center studs,
protruding 3 7/8” into the room. It is recommended to
attach a 2” x 4” cleat to studs, level with bottom of the
opening to support cabinet when installing.
Surface Mount
Installed directly onto the wall, with no cutout, centered
and anchored on secure stud. Will protrude 7 3/4” into
room. Optional surface mount kit is available to finish
sides of unit and recommended for complete installation.
Electrical Requirements for E-42
Unit requires 115/120v, 15 amp. supply line. Pigtails are
provided in the bottom of wire raceway for hookup to
supply line. Make entrance into knockout provided in top
of raceway through le-hand vent hole.
Recommended Standing Room Clearance
Be sure to check that you have adequate standing space
(at least 24”) to stand beside the ironing board to iron.
Installation Heights
Use the provided Installation Height Chart on page 1 to
determine your desired ironing board height.
Door
Ironing center comes standard with a flat maple veneer
door and a variety of additional door options. Door
opens approximately 180°, flush against the wall. Please
be sure to allow 16” to the side of unit for the door to
open fully open.
Hinge Side
Unit comes standard with the hinge on the right. A le
side hinge can be requested when placing order.
Unfinished Cabinet
The exterior of the cabinet is unfinished and ready to be
painted or stained to match existing decor.
Questions?
Give us a call at 1-800-536-9495
or email [e-mail]
Items to Note - Continued: