Specification Sheet

Board automatically engages to low position each time
the board is lowered for use. High position requires
adjustment and engages back to low position each time
the board is put away.
Height Adjustments
Minimum Maximum
Cut Opening (Default) (Adjusted)
Above floor Position Position
31” 38” 42”
30” 37” 41”
29” 36” 40”
28” 35” 39”
27” 34” 38”
26” 33” 37”
25” 32” 36”
Product Model: ANE-42
Dimensions (Actual Size)
Overall height: 52”
Overall width: 15”
Overall depth including door: 7 3/4”
Dimension from wall to outer
Edge of door (when recessed): 3 7/8”
Penetration into opening: 3 7/8”
Rough opening height: 51 1/4”
Rough opening width: 14 3/8”
Wall opening depth: 3 7/8”
Opening dimensions listed above
Overlap distances when using wall
Top overlap: 3/8” Right side overlap: 3/8”
Bottom overlap: 3/8” Left side overlap: 3/8”
Additional Information
• Unit may be surface mounted (unit extends
approximately 7 3/4” into room) or recessed
(unit extends approximately 3 7/8” into room)
into any wall with standard 16” center studs.
• See table bottom right to determine desired
ironing board height above the floor. The
user can adjust height of board after
installation with a 4” differential between a
maximum and minimum height.
• Unit can be provided with a left hinged door
upon request. Right hinge is standard.
• Comes standard with wood veneer door.
• Recommended to attach 2” x 4” cleats to
studs, level with the bottom of opening (for
support when recessing unit.)
• Door opens approximately 180°. Allow at
least 16” to the side of the unit for door to
swing open (door hinges on full length piano
hinge.)
• Options include: Surface mount trim
(necessary for surface mounting), oak, maple,
pine, or white raised panel door, flat white
door, glass mirrored door, or no door, rough-in
kit, and iron.
See Page 2 for additional information
Specifications | February 2015