Installation Manual MODEL ANE-42
GET TO KNOW YOUR UNIT 1 2 1. CROSS BRACES Tools Needed: - Stud Finder - 12-14” Level - Tape Measure - Small Flathead Screwdriver - Electric Drill (with 1/4” & 1/8” drill bit) - 1/4” Nut Driver (optional) - Safety Glasses - Utility Knife 2.
PRE-INSTALLATION 1. DETERMINE MOUNTING HEIGHT Using the charts provided, determine the mounting height above floor (the distance between the floor and the bottom of the cabinet). First choose your desired ironing board height from the left column, then locate the corresponding mounting height in the right column. Desired Ironing Board Height Mounting Height Above Floor 36” 35” 34” 33” 29” 28” 27” 26” 2. LOCATE STUDS & UTILITIES Using a stud finder, locate the wall studs to be used for mounting.
3. ENSURE ADEQUATE SPACE Refer to the chart provided below to ensure adequate clearance for ironing. The cabinet door opens at 180 degrees; allow 16” from side of cabinet for door to fully open. ANE42 1. Distance needed on either side of unit to fully swivel the board 145/8” 2. Distance from wall to tip of ironing board 467/8” 3. Distance from wall to board when in full swivel position 327/8” 4.
RECESSED INSTALLATION Note: Instructions based on installation between 16” on-center studs. 3. PRE-DRILL HOLES 1. CUT WALL OPENING Your unit will be attached to the studs by screws in the upper and lower sides of the cabinet. Cut an opening into the wall based on unit dimensions given below. 143/8” x 511/4 x 37/8” Using a 1/8” drill bit, pre-drill holes into the sides of the cabinet, 14” from the top and 21/2” from the back. 2.
4. INSTALL UNIT IN WALL 6. REMOVE BRACKET SCREW Locate side ironing board brackets that are secured to cabinet with three screws. Then remove the top screw from each bracket. This is where the bottom part of your cabinet will be secured to the studs. Begin installation by carefully lifting unit into the wall opening. Make sure the cabinet is plumb and level. If needed, add shims to help unit fit snug in place. 5.
SURFACE MOUNT INSTALLATION 3. LOCATE & MARK STUD 1. PREPARE CABINET Screws will be drilled through the upper and lower cross braces inside the cabinet. Determine location of screws, ensuring that the location of the mounting screw is as close to the center of the cabinet as possible. 2. PRE-DRILL PILOT HOLES Using a 1/4” drill bit, pre-drill holes in the upper and lower cross braces inside the cabinet as determined in previous step.
. REMOVE BRACKET SCREW Locate side ironing board brackets that are secured to cabinet with three screws. Then remove the top screw from each bracket. Replace with a #14 x 3/4” Phillips screw. This will add stability long-term. 9.
