Installation Guide

5. ATTACH CABINET TO STUDS
Using the pre-drilled holes in top
of cabinet, attach unit to studs
with two #10 x 1
1/2
” screws for top
installation.
Locate side ironing board brackets
that are secured to cabinet with
three screws. Then remove the
top screw from each bracket. This
is where the bottom part of your
cabinet will be secured to the
studs.
Pre-drill holes into the cabinet using
the holes in side brackets where
screws were just removed.
Finish installation by screwing the
two #14 x 2
1/2
” screws into the
pre-drilled holes to secure bottom
part of cabinet into the cabinet.
FOR MODELS AE46 & AE42:
Please refer back to electrical
instructions to complete the
electrical part of your installation.
6. REMOVE BRACKET SCREW
8. INSTALLATION COMPLETE!
Cabinet is now fully installed! If desired,
decorative trim or molding may be
added to cover an irregularities in the
wall.
Example shown with studs
to illustrate mounting.
Swivel Installation - 7
7. PRE-DRILL HOLES IN SIDES
MODELS AE46 & AE42:
Refer to electrical instructions on
pg.17 before proceeding to next step.
MODELS ANE46 & ANE42:
Proceed to next step.
DO NOT attempt to install your own
electrical to unit. Warranty is voided if
independent electrical is installed.
4. INSTALL UNIT IN WALL
Begin installation by carefully lifting unit
into the wall opening. Make sure the
cabinet is plumb and level. If needed,
add shims to help unit t snug in place.