Installation Manual

ManualsBrandsIron-A-Way ManualsIroning46 Inch Ironing Center with 90° Swivel Ventilated Board, Hot Iron Storage, 60-Minute Safety Timer, Storage Shelves, Garment Bar, Adjustable Swivel, Built-In Spotlight, Built-In Safety Switch, and UL Listed: Flat White Door, Left Hinge

ELECTRICAL INSTALLATION

Models | AE-46, E-46, AE-42, E-42, UD-42

ATTENTION:

TURN OFF POWER AT SERVICE ENTRANCE BEFORE

INSTALLING, WIRING, OR SERVICING THIS PRODUCT

ITEMS TO NOTE

Instructions for electrical models ONLY

DO NOT attempt to install your own outlet or

electrical hook-up in non-electrical models

NE-46, NE-42, ANE-46, ANE-42, or IAW-42. This

can cause an electrial hazard and will void the

warranty of your unit.

All electrical work must be done in accordance with

all applicable electrical codes.

SUPPLY LINE 110 Volt/15 AMPS.

STEP ONE: Prepare Electrical Raceway

STEP FOUR: Connect Electrical Wires

STEP TWO: Remove Electrical Knockout

STEP THREE: Prepare Raceway

TURN POWER OFF AT SERVICE ENTRANCE.

Then, begin installation by removing the screws at the top

and bottom of electrical raceway to access the inside.

A black and white pigtail are provided for electrical

hook-up located near bottom of raceway. Connect supply

wires to these pigtails.

DO NOT attempt to connect to any other location inside

the electrical raceway. Doing so will cause the electrical

features to malfunction.

A green ground wire is provided and secured with a star

washer to the back of the electrical channel. Connect

your own ground to that location or attach to the location

opposite the existing ground and add your own star

washer.

Locate and remove the knockout at the top of the raceway

and install a 3/8” Romex connector in its location.

If surface mounting, a vent hole will need be made

through the back side of the cabinet, 24 1/2” down from

top of cabinet, and 2 13/16” from cabinet le side.

Verify that there is ample supply wire (48” is

recommended) available to run from the top of the ironing

center to the location of the provided black and white

pigtails.

Begin to place the ironing center into its location

(supported by cleat if recessed or with the 2 x 4 braces if

surface mounted) while feeding supply wire through the

designated vent hole.

Return to Swivel or Non-Swivel instructions to complete

installation of unit to the wall. When finished, return to

complete final steps here.

INSTALLATION COMPLETE!

ELECTRICAL | PG. 7