Installation Manual

NON-SWIVEL
SURFACE MOUNT INSTALLATION
Models | E46, NE-46, E-42, NE-42, IAW-42
STEP ONE: Locate Stud & Pre-Drill Holes
STEP TWO: Install Unit on Wall
STEP THREE: Apply Trim
*** PLEASE NOTE: Under no circumstances should the ironing board and/or
the support mechanism be removed from the cabinet during installation.
Locate and mark stud on wall. Cut two 2 x 4 braces (not provided) to the
desired mounting height (determined in Step Three of Pre-Installation) to use
for bracing the unit during installation.
Using a 3/16” drill bit, pre-drill hole into center of the top cleat of cabinet (FIG
5.1)
With 2 x 4 braces in place for support (FIG 5.2), place unit on wall, centering
with desired stud.
Mark the location for mounting by placing the drill bit through the pre-drilled
hole in cabinet. Dimple the wall by lightly pushing the drill bit into the dry
wall. Set unit aside, then adjust location if not centered on stud, and pre-drill
hole in wall for mounting.
Apply trim [not provided] to sides of cabinet to flush the side wall with the
cabinet trim (FIG 5.3) to create a sleek look (excludes IAW-42).
Note: May use custom trim or purchase Surface Mount Trim from Iron-A-Way
directly. Please call 1-800-536-9495 for more information.
MODELS E-46 & E-42:
PLEASE REFER TO ELECTRICAL INSTRUCTION
ON PG. 7 BEFORE PROCEEDING.
INSTALLATION COMPLETE!
FIG. 5.1
FIG. 5.2
FIG. 5.3
NON-SWIVEL | PG. 6
Partially insert one #14 x 4” screw (IAW-42 use #14 x 2 1/2” screw) into the
pre-drilled cabinet hole. Then, using 2” x 4” braces, place unit back on the wall
(FIG 5.2) and fully insert screw through cabinet cleat and into stud. Remove
braces. Plum and level unit.
Using 3/16” drill bit, pre-drill hole through the center of the bottom cleat of
cabinet into stud. Insert remaining #14 x 4” screw (IAW-42 use #14 x 2 1/2”
screw) through cleat into stud to fully anchor the unit.