Installation Manual

NON-SWIVEL
RECESSED MOUNT INSTALLATION
Models | E-46, NE-46, E-42, NE-42
STEP ONE: Cut Rough-In Opening
STEP TWO: Pre-Drill Holes
STEP THREE: Place Unit in the Wall
STEP FOUR: Secure Cabinet
*** PLEASE NOTE: Under no circumstances should the ironing board and/or
the support mechanism be removed from the cabinet during installation.
FIG. 4.1
FIG. 4.2
Drywall not shown.
Beginning with the mounting height determined in Step Three of
Pre-Installation, cut an opening in the wall based on dimensions given below
for your specific model:
E-46, NE-46: 59 7/8” H x 14 3/8” W x 3 7/8” D
E-42, NE-42: 51 1/4” H x 14 3/8” W x 3 7/8” D
Next, attach a 2 x 4 cross support cleat (not provided) between studs, level
with bottom of opening (FIG 4.1)
Using an 1/8” drill bit, pre-drill holes in both side walls of the cabinet, under
the top and bottom shelves (2 per side), 2 1/2” from the back wall (4.2).
Carefully li and place unit into the wall opening. Plumb and level the cabinet,
shimming to fit if necessary.
Finally, using pre-drilled holes from step three, attach cabinet to studs with
four #10 x 1 1/2” provided screws (FIG 4.2).
MODELS E-46 & E-42:
PLEASE REFER TO ELECTRICAL INSTRUCTION
ON PG. 7 BEFORE PROCEEDING.
INSTALLATION COMPLETE!
PRO TIPS:
ELECTRICAL
If installing an electrical unit, remove
electrical raceway before pre-drilling
top installation holes for easier access.
WALL IRREGULARITIES
Decorative trim may be added to cover
any irregularities in the wall aer
installation.
NON-SWIVEL | PG. 5