Installation Manual
ADJUSTABLE SWIVEL
RECESSED MOUNT INSTALLATION
Models | AE-46, ANE-46, AE-42, ANE-42, UD-42
STEP ONE: Cut Rough-In Opening
STEP TWO: Pre-Drill Holes
STEP THREE: Place Unit in the Wall
STEP FOUR: Secure Top of Cabinet
STEP FIVE: Secure Bottom of Cabinet & Anchor Swivel
*** PLEASE NOTE: Under no circumstances should the ironing board and/or
the support mechanism be removed from the cabinet during installation.
FIG. 2.1
FIG. 2.2
FIG. 2.3
Drywall not shown.
ADJUSTABLE SWIVEL MODELS | PG. 3
Beginning with the mounting height determined in Step Three of
Pre-Installation, cut an opening in the wall based on dimensions given below
for your specific model:
AE-46, ANE-46, UD-42: 59 7/8” H x 14 3/8” W x 3 7/8” D
AE-42, ANE-42: 51 1/4” H x 14 3/8” W x 3 7/8” D
Next, attach a 2 x 4 cross support cleat (not provided) between studs, level
with bottom of opening (FIG 2.1)
Using an 1/8” drill bit, pre-drill holes in both side walls of the cabinet, under
the top shelf (1 hole per side), 2 1/2” from the back wall (FIG 2.2)
Carefully li and place unit into the wall opening. Plumb and level the cabinet,
shimming to fit if necessary.
Using pre-drilled holes from Step Two, attach cabinet to studs with two #10 x
1 1/2” provided screws for top installation (FIG 2.2).
Locate swivel brackets near bottom of cabinet and remove top screws only
from both sides. Pre-drill pilot hole into bracket and replace with two #14 x 2
1/2” provided screws (FIG 2.3). This will provide anchoring for your swivel.
MODELS AE-46, AE-42, & UD-42:
PLEASE REFER TO ELECTRICAL INSTRUCTION
ON PG. 7 BEFORE PROCEEDING.
INSTALLATION COMPLETE!
PRO TIPS:
ELECTRICAL
If installing an electrical unit, remove
electrical raceway before pre-drilling
top installation holes for easier access.
WALL IRREGULARITIES
Decorative trim may be added to cover
any irregularities in the wall aer
installation.