2020 Installation Instructions

Ironing Board
Height
Mounting
Height
RECESSED MOUNT INSTALLATION
STEP ONE: Determine Mounting Height
46” Boards: 11”
Ex: Desired Height 35” - 11” = 24” Mounting Height
42” Boards: 7”
Ex: Desired Height 35” - 7” = 28” Mounting Height
FIGURE 1.1
Beginning with the mounting height determined in Step One, cut an
opening in the wall based on dimensions given below for your specific
model:
46” Boards: 59 7/8” H x 143 /8” W x 3 7/8” D
42” Boards: 51 1/4” H x 14 3/8” W x 3 7/8” D
Next, attach a 2” x 4” cross support cleat between studs, level with
bottom of opening (FIG 1.2).
STEP TWO: Cut Rough-In Opening
Using an 1/8” drill bit, pre-drill holes in both side walls of the cabinet,
under the top and bottom cleats (2 per side), 2 1/2” from the back wall.
STEP THREE: Pre-Drill Holes
FIGURE 1.2
Carefully lit and place unit into the wall opening. Plumb and level the
cabinet, shimming to fit if necessary.
STEP FOUR: Place Unit In The Wall
MODELS E46 & E42:
PLEASE REFER TO ELECTRICAL INSTRUCTION ON PG. 7 BEFORE PROCEEDING.
Finally, using pre-drilled holes from step three, attach cabinet to studs
with four #10 x 1
1/2
” provided screws (FIG 1.3).
STEP FIVE: Secure Cabinet
PRO TIPS:
If installing an electrical unit, remove
electrical raceway before pre-drilling top
installation holes for easier access.
INSTALLATION COMPLETE!
Electrical
Decorative trim may be added to cover any
irregularities in the wall ater installation
Wall Irregularities
Drywall not shown.
Identify your desired ironing board height (typical ironing board is
33”-35” high). Then subtract the number below based on the length of
your model’s ironing board to determine mounting height (FIG 1.1).
FIGURE 1.3
NON-SWIVEL
NON-SWIVEL IRONING CENTER | PG. 5
Models | E46, NE46, E42, NE42