Installation Sheet

7. INSTALL UNIT
Begin installation by carefully lifting
unit into position. Then, attach the
cabinet to the wall by fully inserting
the screw in the upper cross brace
into the wall stud.
Make sure the unit is plumb and
level. Shim if necessary. Fully tighten
installation screw.
8. INSERT SECOND SCREW
Insert the second #14 x 4” screw into
the pre-drilled hole in the bottom
brace of the cabinet and attach to
wall making sure cabinet remains
square and level.
11. ADD TRIM
Add Decorative trim or molding to
make cabinet sides ush with the face
frame.
Locate side ironing board brackets
that are secured to cabinet with
three screws. Then remove the top
screw from each bracket. Replace
with a #14 x 3/4” Phillips screw. This
will add stability long-term.
12. REMOVE BRACKET SCREW
6. INSTALL ELECTRICAL WIRING
Verify that there is ample supply wire
available to run from the top of the
ironing center to the approximate
location of electrical pigtails.
Note: A free wire length of 48” is
recommended.
Begin to place the ironing center into
its location while feeding the supply
wire through electrical knockout, and
the 3/8” romex connector through the
back of the raceway.
9. CONNECT WIRES
Connect all power supply wires and
ground wires in accordance with
electrical codes. Trim supply wire as
necessary.
10. REPLACE ELECTRICAL RACEWAY
Place the raceway cover into
position, ensuring that no wires
are pinched. Reinstall the top and
bottom screw to secure in place.
13. INSTALLATION COMPLETE
Cabinet is now fully installed!