Instructions

ManualsBrandsiRobot ManualsRoombaiRobot 800 Series Roomba Vacuuming Robot

Robot Part Care Frequency Replacement

Frequency

Bin After each use -

Filter Once per week

(twice per week in

homes with pets)

Every 2 months

Full Bin Sensors

Front Castor Wheel

Once every 2 weeks Every 12 months

Side Brush

Cli Sensors

Charging Contacts

Once per month

Extractors Once every 4 months

(once every 3 months

in homes with pets)

Every 6-12 months

Note: iRobot manufactures various replacement parts and assemblies.

Youmay purchase replacement parts by visiting www.irobot.com/Roomba800.

If you have questions regarding replacement parts, please contact iRobot

Customer Care for more information.

Regular Robot Care

Recommended Robot Care

To keep Roomba running at peak performance, perform the following

care procedures. If you notice Roomba picking up less debris from your

ﬂoor, empty the bin, clean the ﬁlter, and clean the extractors.

800 Series

Summary of content (4 pages)

PAGE 1
Regular Robot Care Recommended Robot Care To keep Roomba running at peak performance, perform the following care procedures. If you notice Roomba picking up less debris from your floor, empty the bin, clean the filter, and clean the extractors.
PAGE 2
Emptying the bin 1 Press bin release button to remove bin. 2 Open bin door to empty bin. Cleaning the Filter 1 Open the filter door and Cleaning the Full Bin Sensors 1 Remove and empty the bin. remove filter by grasping the tab. 2 Shake off debris by tapping 2 Wipe the sensors with a clean, dry cloth. the filter against the side of your household waste bin. 3 Wipe the inner and outer sensor ports on the bin with a clean, dry cloth. 3 Reinsert filter with the tab facing up.
PAGE 3
Cleaning the Front Castor Wheel Cleaning the Side Brush 1 Pull firmly on the front wheel to remove it. 1 Use a coin or small screwdriver to remove the screw. 2 Remove any debris from inside the wheel cavity. 2 Remove the brush, clean the brush and the brush post, and then reinstall the brush. 3 Spin the wheel by hand. If the rotation is restricted, remove the wheel from its housing and push firmly to remove the axle and clear any debris or hair wrapped around it.
PAGE 4
Cleaning the Sensors and Charging Contacts 1 Wipe the sensors with a clean, dry cloth. Do not spray cleaning solution directly onto the sensors or sensor openings. Wipe the charging contacts on Roomba and the Home Base with a clean, dry cloth. Cleaning the Extractors 1 Pinch the extractor frame release tabs, lift up the extractor frame and remove any obstructions. 2 Remove the extractors and then the extractor caps.