SDS

May cause temporary irritation on skin or eye contact.
Most important
symptoms/effects, acute and
delayed
Treat symptomatically.
Indication of immediate
medical attention and special
treatment needed
Ensure that medical personnel are aware of the material(s) involved, and take precautions to
protect themselves. Show this safety data sheet to the doctor in attendance.
General information
5. Fire-fighting measures
Use extinguishing agent suitable for type of surrounding fire.
Suitable extinguishing media
None known.
Unsuitable extinguishing
media
During fire, gases hazardous to health may be formed.
Specific hazards arising from
the chemical
Self-contained breathing apparatus and full protective clothing must be worn in case of fire.
Special protective equipment
and precautions for firefighters
Use methods for the surrounding fire.
Fire fighting
equipment/instructions
Use standard firefighting procedures and consider the hazards of other involved materials.
Specific methods
No unusual fire or explosion hazards noted.
General fire hazards
6. Accidental release measures
Keep unnecessary personnel away. Wear appropriate protective equipment and clothing during
clean-up. Local authorities should be advised if significant spillages cannot be contained. For
personal protection, see section 8 of the SDS.
Personal precautions,
protective equipment and
emergency procedures
Prevent product from entering drains.
Large Spills: Stop the flow of material, if this is without risk. Dike the spilled material, where this is
possible. Absorb in vermiculite, dry sand or earth and place into containers. Following product
recovery, flush area with water.
Small Spills: Wipe up with absorbent material (e.g. cloth, fleece). Clean surface thoroughly to
remove residual contamination.
Never return spills to original containers for re-use. For waste disposal, see section 13 of the SDS.
Methods and materials for
containment and cleaning up
Avoid release to the environment. Inform appropriate managerial or supervisory personnel of all
environmental releases. Prevent further leakage or spillage if safe to do so. Avoid discharge into
drains, water courses or onto the ground.
Environmental precautions
7. Handling and storage
Wear appropriate personal protective equipment. Avoid release to the environment. Observe good
industrial hygiene practices.
Precautions for safe handling
Protect from freezing. Store away from incompatible materials (see Section 10 of the SDS).
Conditions for safe storage,
including any incompatibilities
8. Exposure controls/personal protection
No exposure limits noted for ingredient(s).
Occupational exposure limits
No biological exposure limits noted for the ingredient(s).
Biological limit values
Good general ventilation should be used. Ventilation rates should be matched to conditions. If
applicable, use process enclosures, local exhaust ventilation, or other engineering controls to
maintain airborne levels below recommended exposure limits. If exposure limits have not been
established, maintain airborne levels to an acceptable level.
Appropriate engineering
controls
Individual protection measures, such as personal protective equipment
Not normally needed.
Eye/face protection
Skin protection
Not normally needed. Gloves are recommended for prolonged use.
Hand protection
Not normally needed.
Other
In case of insufficient ventilation, wear suitable respiratory equipment.
Respiratory protection
Wear appropriate thermal protective clothing, when necessary.
Thermal hazards
2 / 6
Material name: Braava jet Hard Floor Cleaning Solution
948584 Version #: 01 Revision date: - Issue date: 13-March-2019
SDS US