Installation Guide

HANDSET PAIRING
RECEIVER RATING REMOTE
Input: 230-240VAC ~ 50Hz
Output: 2 X 240VAC ~ 50Hz switched
Max. Load: 2400W MAX. TOTAL
Battery: 2 x ‘AAA’
Range: Up to 50m - line of sight
Freq: 800MHz
Spa Electrics
7 STATIC COLOURS
POWER BUTTON
WITH LED INDICATOR
CHANNEL SELECTION
4 MULTI-COLOUR MODES
I - Oceanic Views
II - Transcendence
III - Outback Australia
IV - Spring Equinox
BRIGHTNESS CONTROL
NOTE: The iRIS handset requires an initial
button press to ‘wake-up’ the handset.
To ‘wake-up’ the handset, press the power
button once, the LED indicator light will
illuminate to signal it is active.
After 2 minutes of inactivity, the remote handset
will return to ‘sleep mode’.
MODE
LED INDICATOR COLOUR
BLUE - POOL & SPA
GREEN - POOL ONLY
RED - SPA ONLY
INSTALLATION GUIDE
HANDSET OPERATION
TECHNICAL SPECIFICATION
FOR ASSISTANCE PLEASE
CONTACT SPA ELECTRICS
ph: [phone]
[e-mail]
www.spaelectrics.com.au
CONDITION CORRECTIVE ACTION
Flashing power indicator on handset Low Battery - Replace 2 x AAA Batteries in handset
Intermittent communication between
handset and the Reciever
- Reset receiver memory
- Pair handset to receiver
(see “handset pairing” for details)
TROUBLE SHOOTING
STEP 1
STEP 2
Your Remote handset should come pre-assigned to your
receiver. However if it is not paired or you would like to
program a second handset, please follow the below
instructions:
Press the ‘LEARN’ button on the base of the receiver. The
receiver will now switch to learning mode, indicated by the
red LED located next to the ‘LEARN’ button.
Within 7 seconds press any of the buttons on the Remote
Handset. The remote handset is now assigned to the
receiver.
To reset the receiver memory, press and hold the ‘LEARN’
button continuously; The LED indicator will flash fast
initially then flash slow indicating the memory has been
erased. Once erased, release the ‘LEARN’ Button and
complete steps 1 & 2 to program the handsets.
MEMORY RESET
20170720