Operation Manual

Training Mode
33
Using Training Mode
 Go to Settings > Training Mode.
 Select Training mode.
The option Start to create a new training results set is now selected.
 Click OK to close the Training Mode settings for now.
The other options are explained in Combining Training Mode with Training Results sets below.
 Scan or Open your document.
 At the end of the recognition, Readiris enters the Training Mode.
The characters the recognition system isn't sure of are displayed.
If the results are correct:
 Click the Learn button to save the result as sure.
The training results are temporarily stored in the computer memory, for the duration
of the recognition. When you scan a new document, you will have to go through the
same steps again.
To avoid having to go through the same steps, you can combine Training Mode with
Training Results sets.
 Click Finish to accept all solutions the software offers.
If the results are incorrect:
 Type in the correct characters and click the Learn button.
Note: if you are dealing with documents that contain special characters that are not
available on your keyboard, click the browse button to open the Character Palette.
Double-click the character you want to insert.
You can also drag and drop a character from the Character Palette to the character
field in Training Mode.