Operation Manual

Section 4: Selecting the Recognition Options
When you select Read Font Dictionary, Readiris only recognizes the character shapes stored in the
dictionary but doesn't add the new training results, even if the Training Mode is enabled. Note
however that it can still be useful to use the Training Mode to check, and if necessary, correct the
recognition results which are not saved in the font dictionary.
Caution: make sure you do not open an existing dictionary while the dictionary mode is set to New
Dictionary. This will erase the contents of the existing dictionary and create a new one using the
same name.
Using the Training Mode
• When you are done configuring the Training and Font Dictionary options, open or scan your
documents.
• At the end of the recognition, Readiris enters the Training Mode.
The characters the recognition system isn't sure of are displayed.
If the results are correct:
o Click the Train button to save the result as sure.
If you are not using a Font Dictionary, the training results are temporarily stored in
the computer memory, for the duration of the recognition. When you scan a new
document, you will have to go through the same steps again.
If you are using the New Font Dictionary option or Append Font Dictionary option,
the results are saved in the dictionary and you won't have to go through the same
steps again.
o Click Finish to save all solutions the software offers.
31