Operation Manual

Chapter 3 – Starting up

1. Check the default scanning parameters

Before you start scanning, you must carefully check the scanning

parameters. This is done in the Page Setup window. See:

Scanning, Page Setup.

2. Launch the scanning

You can then launch the scanning: put your documents in the

scanner paper feeder and launch the scanning. See: Scanning,

Scanning operations.

3. Process your documents

Once the scanning is complete, the application automatically

prompts you to process the documents. Click Yes in the

displayed dialog box. The output processing takes place.

What to do if the solution package does not exactly fit my

needs?

Let's imagine, for example, that you want to separate your invoices

using a blank page, rather than a barcode*. In this case, the solution

package as such will not work properly.

(*) The default settings of each project are described in the About window of the

Start up window.

You must thus:

1. Create a new project

You must create a new project based on the chosen solution

package. See: Starting up, Creating a project. The settings remain

the same as for the chosen solution package.

2. Change its project setup

In the new project, change the project settings according to your

needs. See the chapter on Project setup.