Operation Manual

IRISPowerscan
TM
User Guide
129
Tip:
Refer to the separate IRISConnect documentation to make full use of the
IRISConnect Connectors.
Refer to the section Using the Configuration Wizards for more information
about the wizards.
Using the Configuration Wizards
The Configuration Wizards allow you to set up the connectors in a
few easy steps. They guide you through the different steps of a
quick, basic configuration.
Once you have gone through the steps, the documents you scan and
process are exported via IRISConnect. The IRISPowerscan Project
Setup is unavailable. This means you cannot change any other
(advanced) IRISPowerscan settings outside the Wizard.
All Wizards are structured in the same way, for every connector.
There are only slight differences when it comes to setting up a
connection. This is due to the fact the various ECM systems require
different login credentials.
Starting the Wizard
In the IRISPowerscan start-up screen, double-click the Quick
Project of your connector to start the Configuration Wizard.
Step 1: Connect to the Server
This is the mandatory step.