Quick Start Guide

 When the Tour is finished, click Done.

 The Quick Start screen is now displayed and shows the three main scanning options.

See Scanning for more information.

Note: when the IRISPen

is inactive for 12 minutes, it auto powers off.

4. Scanning

In this section we explain the different scanning possibilities of the IRISPen

Before you begin, make sure the IRISPen

is powered on and connected correctly. If not, it says

Disconnected in the application screen.

Important Scanning Tips

Bear in mind the following scanning tips that help improve the scanning quality:

 Hold the pen upright to scan text. Do not scan in a 45 degree angle or less.

 Make sure both sharp ends of the scanner tip always touch the page during scanning.

 Scan one line of text at a time. Make sure the line is approximately in the middle of the two

scanner tips.

 Avoid scanning too slowly. Slide the IRISPen

smoothly, in a fluid motion.

 Avoid applying excessive pressure. Otherwise, the scanning may result in jerky, uneven

motions.