Use and Care Guide

ManualsBrandsIris ManualsHome Automation Controllers3460-L

SMART BUTTON

model

3460-L

lowe’s item #

690401

troubleshooting

Step 1

Open the battery tray on the

side of the device. Remove

battery and replace with a new

CR-2450 battery. Reassemble

and test operation.

Step 2

Remove battery. While holding

down the button, reinsert

battery and continue to hold

for two seconds, then release

button. This will factory reset

the device. Repeat the “Getting

Started” steps to rejoin the

ZigBee network.

for additional help

Check out support.IrisByLowes.

com or call 1-855-469-IRIS (4747).

technical specifications

Power

Rated: 3V

Battery: CR-2450 (1x)

Battery Life: Up to 2 years

Environmental

Operating Temperature: 0° to 40°C

Shipping/Storage

Temperature: -20° to 50°C

Humidity Range: 0 to 90% RH.

(non-condensing)

Approvals

Wireless RF Protocol

Protocol: ZigBee HA 1.2

TX Strength: +3 dBm

RF Channels: 16

Range: 130 ft. (40m) LOS

approvals (english)

This device complies with Part 15 of the FCC rules. Operation is subject to the

following two conditions:

(1) This device may not cause harmful interference and

(2) This device must accept any interference received, including interference

that may cause undesired operation.

Conforms to FCC Part 15B

Contains FCC ID: T3L-SS011

IC: 12192A-SS011

Industry Canada licence-exempt RSS Standards. Operation is subject to the

following two conditions: (1) This device may not cause harmful interference,

and (2) This device must accept any interference received, including interfer-

ence that may cause undesired operation.

Under Industry Canada regulations, this radio trans mitter may only operate

using an antenna of a type and maximum (or lesser) gain approved for the

transmitter by Industry Canada. To reduce potential radio interference to

other users, the antenna type and its gain should be so chosen that the equiv-

alent isotropically radiated power (e.i.r.p.) is not more than that necessary for

successful communication.

This equipment complies with FCC and IC radiation exposure limits set forth

for an uncontrolled environment. This equipment is in direct contact with

the body of the user under normal operating conditions. This transmitter

must not be co-located or operating in conjunction with any other antenna

or transmitter.

Changes or modiﬁcations not expressly approved by Lowes, Inc. could void

the user’s authority to operate the equipment.

For more information, visit IrisByLowes.com.

approvals (franÇais)

Le présent appareil est conforme aux CNR d’Industrie Canada applicables

aux appareils radio exempts de licence. L’exploitation est autorisée aux deux

conditions suivantes:

(1) l’appareil ne doit pas produire de brouillage, et

(2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi,

même si le brouillage est susceptible d’en compromettre le fonctionnement.

Conformément à la réglementation d’Industrie Canada, le présent émetteur

radio peut fonctionner avec une antenne d’un type et d’un gain maximal

(ou inférieur) approuvé pour l’émetteur par Industrie Canada. Dans le but de

réduire les risques de brouillage radioélectrique à l’intention des autres utili-

sateurs, il faut choisir le type d’antenne et son gain de sorte que la puissance

isotrope rayonnée équivalente (p.i.r.e.) ne dépasse pas l’intensité nécessaire à

l’établissement d’une communication satisfaisante.

Pour plus d’informations, visitez IrisByLowes.com.