Owner Manual

WARNING
• Battery Level indicator light will blink when battery
power is low.
• When battery runs out of power, Battery Level
indicator light will blink rapidly before shutting off,
and motor will stop. Please recharge.
CHARGING BATTERY
Do not charge battery with other charger except the original brand.
Battery does not come fully charged. Please charge to full power before first use. Full charge
will take approximately 3.5 hours.
Please do not use the device while charging.
1. Please put the battery into the vacuum cleaner.
Place the battery into the vacuum. Press battery into the socket until you
hear a clicking sound.
*Failure to fully insert the battery into the socket will affect operation and
can result in injury or damage.
Battery
Battery release
button
Insert until clicking
sound is heard
Please insert the battery tightly and
firmly into the socket until there is a
clicking sound.
Clicking
Sound
3. Insert the charger into power socket.
Please insert the charger into the power socket tightly and firmly.
* The Battery Level red indicator light means the product has started
charging.
2. Plug the charger plug into the power outlet.
Power outlet
Battery Charger plug
5. Removing the battery.
Press the battery release button and take out the battery.
4. Battery is fully charged
.
The indicator light will shut off when done charging.
• For first time use or non-use for more than 6 months, please
charge 2 or 3 times before use to achieve full charge.
• If more than 10 days since last use, charge before next use.
• Continual charging will decrease charge hold time.
• Charging and running time will vary due to temperature and
operating conditions.
• Charge between temperatures of 41°F/5°C and 95°F/35°C.
Charging in too low or too high temperatures can cause decreases
in working time or lengthening in charging time.
• Charger will be warm. This is normal.
ON
Charging
OFF
Finished
Standard charging time about 3.5 hours
Battery Level indicator light
High
Low
Battery Level
Safety Lock
(hold for 3 sec)
HOW TO USE
3. Start the product.
Pressing the Menu ON/OFF button changes the mode.
• Press the Menu ON/OFF button to change to High mode.
• Press the Menu ON/OFF button again to change to Low
mode.
Do not use this vacuum cleaner to clean the following objects:
Liquid, wet litter/debris, powder, broken glass, sharp or pin type objects, sand or gravel, plastic
bags.
Please do not clean large amounts of litter/debris in one pass to avoid blocking the intake port and
decreasing suction.
Do not use on floors, walls or furniture. Do not pull on the main body and avoid hitting walls or
furniture.
Empty the dust cup after use to avoid decreased suction or issues with the sensor.
CAUTION
1. Adjust the collection head angle.
Please place the vacuum on the floor, then adjust the angle up
and down by hand.
• Please adjust the vacuum body to the horizontal position,
which should be used for soft surfaces such as bedding.
• The collection head is fastened in horizontal position by a
magnet to keep it in place during use.
Storage position
Carpet or car cushion
material angle.
Bedding/soft
materials
angle
2. Unlock.
Hold the Menu ON/OFF button for 3 seconds, wait for the Safety
Lock indicator to light up, then start cleaning as directed below.
• Safety Lock will automatically lock again after one minute
of non-use.
• Device will not work when locked. Pressing the Menu ON/
OFF button to start when it is locked will cause the Safety
Lock light to blink.
Safety Lock
indicator light
Menu
ON/OFF
High
Low
Battery Level
Safety Lock
(hold for 3 sec)
4. When nished cleaning.
Press the Menu ON/OFF button to change the mode until the
vacuum stops and the indicator light shuts off.
• Device will automatically lock after one minute of
non-use.
• Please follow step 2 to restart.
High
Low
Battery Level
Safety Lock
(hold for 3 sec)
High
Low
Stop
Indicator light
Menu
ON/OFF
Indicator light
High
Low
Battery Level
Safety Lock
(hold for 3 sec)
Menu
ON/OFF
Blinking: Low power
Blinking rapidly (then off): No power
5 6