Tus neeg siv phau ntawv

16
CABLE CONNECTORS
Cabling must have a male XLR connector on one end and a female XLR connector on
the other end.
3-PIN TO 5-PIN CONVERSION CHART
3-PIN TO 5-PIN CONVERSION CHART
Note! If you use a controller with a 5 pin DMX output connector, you need to use a 5 pin
to 3 pin adapter. The chart below details a proper cable conversion:
caution:Do not allow contact between the ground and the fixtures chassis ground. Grounding the
ground can cause a ground loop, and your fixture may perform erratically. Test cables with an ohm
meter to verify positive pole and to make sure the pins are not grounded or shorted to the shield or
each other.
DMX connector configuration
GROUND
Conductor
Ground/Shield
Data ( - ) signal
Data ( + ) signal
Do not use
Do not use
3 Pin Female (output)
Pin 1
Pin 2
Pin 3
5 Pin Male (Input)
Pin 1
Pin 2
Pin 3
Do not use
Do not use