Instruction manual

THE TRANSISTOR THE WHITE LINE
8
NFC (Near Field Communication)
NFC enable you pair and connect with Bluetooth
devices in a easy way.
1. Press button repeatedly to select
Bluetooth mode.
2. Make sure that your NFC is turned “On” on your
mobile device.
3. Hold your mobile device about 2cm close to
NFC chip for receiving an auto-connection
between your mobile device and radio.
4. Your device then will turn-on Bluetooth
automatically and will pair your device with radio.
No additional settings are necessary.
Aux in Mode
Aux in allows for quick and easy connection to an
MP3 player or other external audio sources.
1. Before connecting to the mains socket, use a
3.5mm audio cable (not supplied) to connect to
your external audio device through the AUX IN
socket on the side of unit.
2. Connect power cord to mains socket, press
button to switch unit on.
3. Press button repeatedly to select Auxiliary
Input mode.
4. In Aux in mode, you may operate your audio
device directly for playback features.
5. To gain optimal volume levels, adjusting the
output volume level on the audio device as well
is recommended.
Display
This feature enables you to select the music
information showing on the display.
1. Press and hold button, and then press
or buttons to select Display, press
button to confirm.
2. Press or buttons to browse between
Time and Date.
General Operation
Setting Alarm
Your radio includes dual alarms. Set Alarm, making
sure set time at first.
1. Press and hold button, and then press
or buttons to select Alarm, press
button to confirm.
2. Press or buttons to select ‘Alarm 1
Setup’ or ‘Alarm 2 Setup’, and then press
button to confirm.
3. Press or buttons to select options, and
then press button to confirm the setting.
Alarm states:
On or Off
Alarm time:
On Time: 00:00 (manually
set up the time )
Alarm
duration time:
15/30/45/60/90 minutes
Alarm source:
DAB, FM or Buzzer
Last listened:
Only available when DAB
or FM source is selected
Alarm active
day:
Daily, Once, Weekends or
Weekdays
Alarm
volume:
Press or buttons
to set the alarm volume
4. When display shows 'Alarm Saved', the alarm
setting is successful.
5. To turn off alarm, press button when the
alarm sounds.
6. To cancel Alarm, refer to steps1-3 to set Alarm
states to ‘Off'.
Note:
Alarm doesn’t work while unit power off under battery
mode.