Specifications

WIFI-2-V897USA1
IEEE 802.11a/b/g/n/ac 2T2R
page 22
of
25
7. Statement：
FCC Radiation Exposure Statement
Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions (1)this device
may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
The modular can be installed or integrated in mobile or fix devices only. This modular be installed in any portable device,
for example, USB dongle like transmitters is forbidden. This modular complies with FCC RF radiation exposure limits
set forth for an uncontrolled environment. This transmitter must not be collocated or operating in conjunction with
antenna or transmitter. If the FCC identification number is not visible when the module is installed inside another device,
then the outside of the device into which the module is installed must also display label referring to the enclosed module.
This exterior label can use wording such as the following:” Contains Transmitter Module FCC ID: 2ACHK-
01070189
Or
Contains FCC ID: 2ACHK-
01070189
when the module is installed inside another device, the user manual of this
device must contain below warning statements;1. This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions :(1) This device may not cause harmful interference.(2) This device must accept
any interference received, including interference that may undesired operation.2. Changes or modifications not
expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
The devices must be installed and used in strict accordance with the manufacturer’s instructions as described in the
user documentation that comes with the product. This device is intended only for OEM integrators under the following
conditions:1) The antenna must be installed such that 20 cm is maintained between the antenna and user.2) The
transmitter module may not be co-located with any other transmitter or antenna. Module Antenna Type 1: 2.4G ANT,