User's Manual

Mars1417V Digital Flat Panel Detector User Manual
40
................................................................................................................................................iRay
Technology Co. Ltd.
 Insert the battery；
 Press the power button about 4s to shut down the detector；
 In the shutdown state, press the power button for 3 times to exit ship mode.
Charger
 Power on charger；
 Insert the battery into the charger for 3~5s to exit ship mode
3.4. Software Installation
In the case of iDetector not work, please install Microsoft .NET Framework 4.5 first, then install
vcredist_x86_2013（or vcredist_x64_vs2013）. (iDetector should not be used for terminal hospital)
3.5. Panel Infrastructure
Mars1417V supports two connection modes as follows, the IP address and other information mentioned
below is as the example, user should configure the connection with the specific requirement.
1) Wireless Client Mode
2) Wireless AP Mode
To build connection between workstation and Panel, User should follow steps below.
3.5.1. Wireless Client Mode
To complete Wireless Client mode configuration, user has to finish actions listed below.
Configuration of External wireless AP
Connect one end of Gigabit Ethernet
Cable to Workstation,
Connect another end to LAN port of
External wireless AP
/