User's Manual

Installation
KONICA MINOLTA,
INC..………….……………………………………………………………………………………………………
….…………….………..
41
Recover local network IPv4 setting
IP setting
Network mask setting
IP address: 192.168.8.188
Subnet mask: 255.255.255.0
Configuration of detector
Either Wired Cable or Infrared device can be used to configure detector in wireless client mode. The
wired connection should be used by the service operator only.
To start configuration with wired cable. It is necessary to finish 3.4.1.1, then proceed to the steps below.
Connect panel to Workstation with
Ethernet Cable like 3.4.1
Click “Detector”
Click ”Wifi”
Click ”Read Config”
Choose “Client” mode