User's Manual
Table Of Contents
- To Customers
- Contents
- 1.Safety
- 2. General Description
- 3. Installation
- 4.Software Setup
- 5. Operation
- 6. Regulatory Information
- 7. Trouble Shooting
- 8. Service Information
- Appendix
- FCC Regulations:
4. Software Setup
iRay Technology Co. Ltd. 47
Select SSID which
belongs to detectors;
Input password and log
into system
Open SDK and choose
product start connection
After logging in the
detector, User can
Custom AP setting or
Set the Wireless Client
Mode
4.5.2 Configuration of detector
Wired cable can be used to configure panel wireless AP mode. The wired
connection should be used by the service operator only. To start wired cable
configuration, users should finish 4.4, then proceed to the steps below.
Connect panel to
Workstation with
Ethernet Cable like 4.4