User's Manual

Wireless Digital Flat Panel Detector Luna1012X
12 User Manual of Luna1012X
Installation and environment
of use
Do not install the equipment in any of the locations listed
below. Doing so may result in failure, malfunction,
equipment falling, fire or injury.
Close to facilities where water is used
Where it will be exposed to direct sunlight
Close to the air outlet of an air-conditioner or ventilation equipment
Close to heat source such as a heater
Where the power supply is unstable
In a dusty environment
In a saline or sulfurous environment
Where temperature or humidity is high
Where there is freezing or condensation
In areas prone to vibration
On an incline or in an unstable area
Take care that cables do not become tangled during use.
Also, be careful not to get your feet caught by cable.
Otherwise, it may cause a malfunction of the equipment or injury of
the user due to tripping over the cable.
Power supply
Always connect the three-core power cord plug to a
grounded AC power outlet.
To make it easy to disconnect the plug at any time, avoid
putting any obstacles near the outlet. Otherwise, it may not
be possible to disconnect the plug in an emergency.
Be sure to ground the equipment to an indoor grounded
connector. Also, be sure to connect all the grounds for the
system to a common ground.
Do not use any power source other than the one provided
with this equipment.
Otherwise, fire or electric shock may be caused due to leakage.
Handling
Do not spill liquid or chemicals onto the equipment. In case
the patient is injured, it is not allowed to contact with blood
or other body fluids.
Doing so may result in fire or electric shock.
In such a situation, protect the equipment with a disposable cover as
necessary.
Turn OFF the power and pull out the plug to each piece of
equipment for safety when not used.
CAUTION