User's Manual
Table Of Contents
- Contents
- Notices and Conventions
- 1 Safety and Regulatory Information
- 2 Overview
- 3 Installation
- 4 Operation
- Appendix (For Service Personnel Only)
- Software and Settings
- Operating Modes
- Software Installation
- Set the Connection Mode
- Shortcuts
- Establish a Connection with the Detector
- Configure the Detector
- Correction and Calibration Template Generation
- Image Check and Upload
- Defect Template Check and Modification
- Correction and Calibration Management
- Update the Firmware
- Publication History
the maximum value.
This is because the device is designed to operate at multiple power levels so as to use
only the power required to reach the network. In general, the closer you are to a wireless
Base station antenna, the lower the power output.
The exposure standard for wireless devices employing a unit of measurement is known
as the Specific Absorption Rate, or SAR. The SAR limit recommended by the ICNIRP
used by the general public is 2.0W/kg averaged over ten grams of tissue and, is 1,6W/kg
Averaged over one gram of tissue by IEEE Std 1528.
The FCC has granted an Equipment Authorization for this product with all reported SAR
Levels evaluated as in compliance with the FCC RF exposure guidelines.
For this device, the highest FCC reported SAR value for usage is 0.042W/kg.
While there may be differences between the SAR levels of various product and at various
positions, they all meet the government requirements.
SAR compliance for body-worn operation is based on a separation distance of 0 mm
between the unit and the human body. Carry this device at least 0 mm away from your
body to ensure RF exposure level compliant or lower to the reported level. To support
body-worn operation, choose the belt clips or holsters, which do not contain metallic
components, to maintain a separation of 0 mm between this device and your body.
RF exposure compliance with any body-worn accessory, which contains metal, was not
tested and certified, and using such body-worn accessory should be avoided.
IC Notice
This device complies with Industry Canada license-exempt RSS standard(s). Operation is
subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause
undesired operation of the device.
This Class B digital apparatus complies with Canadian ICES-003.
IC:25116-01070189
IC Radiation Exposure Statement
This EUT is in compliance with SAR for general population/uncontrolled exposure
limits in IC RSS-102 and had been tested in accordance with the measurement