User's Manual
Table Of Contents
- Contents
- Notices and Conventions
- 1 Safety and Regulatory Information
- 2 Overview
- 3 Installation
- 4 Operation
- Appendix (For Service Personnel Only)
- Software and Settings
- Operating Modes
- Software Installation
- Set the Connection Mode
- Shortcuts
- Establish a Connection with the Detector
- Configure the Detector
- Correction and Calibration Template Generation
- Image Check and Upload
- Defect Template Check and Modification
- Correction and Calibration Management
- Update the Firmware
- Publication History
Defect Template Check and Modication
The iDetector software provides the ability to check the defect template. If the
template has updates, the user can add and delete pixels or defective lines by
modifying the opened defect template.
Defect Template Check
1. From the Local File page, select Load File.
2. Select the specied defect template, and select Open.
The defect template will be displayed.
Defect Template Modication
1. Open the specied defect template.
The defect management dialog box will be displayed.
2. Locate the pixel that needs to be managed, type the coordinates of the pixel, and
select Add. The information will be added to the template.
Note:
If Delete is selected, the information will be removed from the template.
3. Select Save.
4. It is similar to manage the defect pixel. If the user needs to add the defect line, type
the coordinates of the line, and select Add. If the information needs to be deleted,
select Delete.
Appendix (For Service Personnel Only)
XVIII AJ4312 | 2020-02-10