User's Manual
Table Of Contents
- Contents
- Notices and Conventions
- 1 Safety and Regulatory Information
- 2 Overview
- 3 Installation
- 4 Operation
- Appendix (For Service Personnel Only)
- Software and Settings
- Operating Modes
- Software Installation
- Set the Connection Mode
- Shortcuts
- Establish a Connection with the Detector
- Configure the Detector
- Correction and Calibration Template Generation
- Image Check and Upload
- Defect Template Check and Modification
- Correction and Calibration Management
- Update the Firmware
- Publication History
Image Check and Upload
OPEN provides two features for image check and uploading: Local Image Check and
Panel Image Upload. Local Image Check is used to check images saved in the
workstation. Panel Image Upload is used to upload images stored in the panel.
Local Image Check
1. From the Local File tab, select Load File. Choose the specied le.
2. Choose the images stored in the workstation. The screen will display the images.
Panel Image Upload
Prerequisites:
Make sure the rewall is closed.
1. Select the Images tab from the Detector interface.
2. Select Query Images.
The images stored on the detector will be listed.
3. Select Upload Images and choose the specied image. Select OK.
When the state changes to Success, the image has been uploaded.
The upload process can be canceled by selecting Stop Upload.
The uploaded images are saved in the path of the detector serial number.
Appendix (For Service Personnel Only)
AJ4312 | 2020-02-10 XVII