User's Manual
Table Of Contents
- Contents
- Notices and Conventions
- 1 Safety and Regulatory Information
- 2 Overview
- 3 Installation
- 4 Operation
- Appendix (For Service Personnel Only)
- Software and Settings
- Operating Modes
- Software Installation
- Set the Connection Mode
- Shortcuts
- Establish a Connection with the Detector
- Configure the Detector
- Correction and Calibration Template Generation
- Image Check and Upload
- Defect Template Check and Modification
- Correction and Calibration Management
- Update the Firmware
- Publication History
Conīgure the Detector
1. From the iDetector menu, select the Acquire tab.
2. Acquire the module related setting, such as loading correction and calibration
template, acquiring images.
3. See the SDK module-related settings, such as IP address.
4. See the Detector module related settings, such as trigger module, wireless signal.
5. Calibrate the module related setting, such as making correction and calibration
template. The template in the panel could be uploaded to a workstation, and the
template in a workstation could also be downloaded to panel.
6. See the Local File module related setting, such as import a Raw or DCM image.
Appendix (For Service Personnel Only)
XIV AJ4312 | 2020-02-10