User's Manual
Table Of Contents
- Contents
- Notices and Conventions
- 1 Safety and Regulatory Information
- 2 Overview
- 3 Installation
- 4 Operation
- Appendix (For Service Personnel Only)
- Software and Settings
- Operating Modes
- Software Installation
- Set the Connection Mode
- Shortcuts
- Establish a Connection with the Detector
- Configure the Detector
- Correction and Calibration Template Generation
- Image Check and Upload
- Defect Template Check and Modification
- Correction and Calibration Management
- Update the Firmware
- Publication History
The detector will connect to the wireless AP the next time it is powered on.
10. Congure the external wireless card.
a. Open the local wireless signal list.
b. Select the SSID that belongs to the detectors. Enter the password and select OK.
c. Open the wireless card conguration.
d. Open the IPV4 setting and set the following values:.
• IP setting—IP address: 10.0.1.251
• Network mask setting—Subnet mask: 255.255.255.0
e. Open SDK and select the detector.
f. Select Connect.
Appendix (For Service Personnel Only)
AJ4312 | 2020-02-10 XI