User's Manual
Table Of Contents
- Contents
- Notices and Conventions
- 1 Safety and Regulatory Information
- 2 Overview
- 3 Installation
- 4 Operation
- Appendix (For Service Personnel Only)
- Software and Settings
- Operating Modes
- Software Installation
- Set the Connection Mode
- Shortcuts
- Establish a Connection with the Detector
- Configure the Detector
- Correction and Calibration Template Generation
- Image Check and Upload
- Defect Template Check and Modification
- Correction and Calibration Management
- Update the Firmware
- Publication History
Parameter Description Can be Modied
Integrate Time Should not be modied; keep the original value Yes
Src Port Port number for detector No
Src IP IP address for detector No
Src MAC MAC address for detector Yes
Dest Port Port number for PC No
Dest IP IP address for detector No
Self Clear Enable
Related to Prep CapMode, the value should be
congured as On if Prep CapMode is congured
as PrepCapMode_ClearAcq. Otherwise, the value
should be Off
If the Trigger Mode is Software/Inner, the value
should be On
Yes
Self Clear Span Time Should not be modied; keep the original value Yes
Hvg Prep On Reserved Yes
Hvg XRay Enable Reserved Yes
Hvg XRay On Reserved Yes
Tube Ready Time Reserved Yes
Image Pkg Gap Time Reserved Yes
Out Mode Cap Trigger Reserved Yes
SDK Settings
Parameter Description Can be Modied
Host IP IP Address of local workstation Yes
Host Port Port of local workstation Yes
Ftp Download Host IP FTP download server IP; keep the same as Host IP Yes
Ftp Download Host
Port
FTP download server Port; keep the same as Host
Port
Yes
Appendix (For Service Personnel Only)
AJ4312 | 2020-02-10 III