User's Manual
Table Of Contents
- Contents
- Notices and Conventions
- 1 Safety and Regulatory Information
- 2 Overview
- 3 Installation
- 4 Operation
- Appendix (For Service Personnel Only)
- Software and Settings
- Operating Modes
- Software Installation
- Set the Connection Mode
- Shortcuts
- Establish a Connection with the Detector
- Configure the Detector
- Correction and Calibration Template Generation
- Image Check and Upload
- Defect Template Check and Modification
- Correction and Calibration Management
- Update the Firmware
- Publication History
Tab Description
Remaining power of the battery, shown as a percentage
Progress Bar
If the progress bar
• Is green while taking an x-ray, the image quality is acceptable
• Is not green while taking an x-ray, the image quality will be degraded
General Settings
Parameter Description Can be Modied
Product No. Type number of the detector No
Sub Product No. Sub-type of the detector No
Serial No. Serial number of the panel No
Main Version Version of the rmware of Main FPGA No
Main MB CPU Version Version of the MB CPU of Main FPGA No
MCU Version Version of the rmware of MCU No
Arm Version Version of the App of ARM No
Kernel Version Version of the Kernel of ARM No
Inner Subow Sub work-ow Yes
Prep CapMode Reserved No
Self CapEnable Reserved Yes
Self Cap Span Time Should not be modied; keep the original value Yes
Trigger Mode Trigger mode Yes
Sequence Interval Time Should not be modied; keep the original value Yes
Set Delay Time Exposure window for Freesync mode Yes
Exp Window Time Exposure Window for Software/Inner mode, the
value should not be larger than 10s
Yes
Acquire Delay Time Reserved Yes
Appendix (For Service Personnel Only)
II AJ4312 | 2020-02-10