User's Manual
Table Of Contents
- Contents
- Notices and Conventions
- 1 Safety and Regulatory Information
- 2 Overview
- 3 Installation
- 4 Operation
- Appendix (For Service Personnel Only)
- Software and Settings
- Operating Modes
- Software Installation
- Set the Connection Mode
- Shortcuts
- Establish a Connection with the Detector
- Configure the Detector
- Correction and Calibration Template Generation
- Image Check and Upload
- Defect Template Check and Modification
- Correction and Calibration Management
- Update the Firmware
- Publication History
CAUTION:
Do not spray disinfectants or detergents directly onto the detector.
To prevent damage to the surface of the detector, wipe with a cloth slightly dampened with a
neutral detergent. Do not use solvents such as benzene and acid.
It is recommended to use a waterproof non-woven cover as the isolated layer between
the detector and a patient who is bleeding.
Applied Part
The front and back of the detector is an application part.
Operation
4-2 AJ4312 | 2020-02-10