User's Manual
Table Of Contents
- Contents
- Notices and Conventions
- 1 Safety and Regulatory Information
- 2 Overview
- 3 Installation
- 4 Operation
- Appendix (For Service Personnel Only)
- Software and Settings
- Operating Modes
- Software Installation
- Set the Connection Mode
- Shortcuts
- Establish a Connection with the Detector
- Configure the Detector
- Correction and Calibration Template Generation
- Image Check and Upload
- Defect Template Check and Modification
- Correction and Calibration Management
- Update the Firmware
- Publication History
Action FPD Status
Power Mode Note
Wireless
ConnectionMode
Switch
Power ON
No action
Long hold and
then short click
1. Hold the Mode button
hold for 7 seconds.
2. Release the Mode button
after Mode indicator
starts blinking, and then
press again in 5 seconds.
The mode starts
switching.
3. Press the Mode button to
switch modes.
The Mode indicator
blinks at the
corresponding color.
4. Wait at intended mode,
the Mode indicator will
switch color after several
seconds.
• Blue = client
• Green = AP (Not
used)
Installation
AJ4312 | 2020-02-10 3-7