User's Manual
Table Of Contents
- Contents
- Notices and Conventions
- 1 Safety and Regulatory Information
- 2 Overview
- 3 Installation
- 4 Operation
- Appendix (For Service Personnel Only)
- Software and Settings
- Operating Modes
- Software Installation
- Set the Connection Mode
- Shortcuts
- Establish a Connection with the Detector
- Configure the Detector
- Correction and Calibration Template Generation
- Image Check and Upload
- Defect Template Check and Modification
- Correction and Calibration Management
- Update the Firmware
- Publication History
Button Function
Action FPD Status
Power Mode Note
Power ON
Power OFF
Short hold No action Hold for 4 seconds
Forced restart Long hold No action
Hold for more than 7
seconds.
Release the power button
when the power indicator is
ON.
Exit the battery from
ship mode
Press 3 times No action
Release after two short
presses (interval < 1second).
Enter safety mode Short hold Long hold
Power button: hold for 4
seconds
Mode button: hold for 7
seconds
Forced restart Power ON Long hold No action
Hold for more than 7
seconds, when the Power
indicator is OFF and then ON,
release Power button.
Enter/exit sleep mode Double click No action
Release after two short
presses (interval <1second)
Power OFF Short hold No action
Hold for 4 seconds, Release
the Power button when the
power indicator is OFF.
Restore default
conīguration
Triple check
Short hold
Long hold
1. Hold the Mode button
hold for 7 seconds.
2. Press the Power button 3
times.
3. Short hold the Power
button for 4 seconds.
Installation
3-6 AJ4312 | 2020-02-10