User's Manual
Table Of Contents
- Contents
- Notices and Conventions
- 1 Safety and Regulatory Information
- 2 Overview
- 3 Installation
- 4 Operation
- Appendix (For Service Personnel Only)
- Software and Settings
- Operating Modes
- Software Installation
- Set the Connection Mode
- Shortcuts
- Establish a Connection with the Detector
- Configure the Detector
- Correction and Calibration Template Generation
- Image Check and Upload
- Defect Template Check and Modification
- Correction and Calibration Management
- Update the Firmware
- Publication History
To power on the detector, press and hold the power button for 4 seconds. The detector
must either have a battery installed with >10 % charge or have the DC power
connected.
To power off the detector, press and hold the power button for 4 seconds.
To reset the detector, press and hold the power button for 8 seconds.
Power Indicator
After booting up, the user can check the status LED indicator.
Power Indicator Lighting Status
Operating Status
Operating Battery Capacity DC Input
OFF Power OFF -- --
Orange ON Power ON ≤20% No
Green ON Power ON
• Battery capacity ≥20 %, no DC
input
• DC input (Optional)
Orange Blinking Power OFF <20 % Yes
Green and Orange
Blinking
Power OFF ≥20 % and <95 % Yes
Installation
AJ4312 | 2020-02-10 3-3