User's Manual
Table Of Contents
- Contents
- Notices and Conventions
- 1 Safety and Regulatory Information
- 2 Overview
- 3 Installation
- 4 Operation
- Appendix (For Service Personnel Only)
- Software and Settings
- Operating Modes
- Software Installation
- Set the Connection Mode
- Shortcuts
- Establish a Connection with the Detector
- Configure the Detector
- Correction and Calibration Template Generation
- Image Check and Upload
- Defect Template Check and Modification
- Correction and Calibration Management
- Update the Firmware
- Publication History
X Indicator Operating Status
All off No power input
A indicator on
• AC power input
• Multiple batteries inserted
A indicator on
B and C alternately blink 2 times
Battery insertion self test
A and B indicator on Battery charging
A and C indicator on Battery capacity full, charging
stops
A indicator on
B and C alternately blinking
Battery is not charging properly
Two or more batteries charging cannot be charged at the same time. Charging will
automatically stop if more than one battery is inserted.
Overview
AJ4312 | 2020-02-10 2-5