User's Manual
Table Of Contents
- Contents
- Notices and Conventions
- 1 Safety and Regulatory Information
- 2 Overview
- 3 Installation
- 4 Operation
- Appendix (For Service Personnel Only)
- Software and Settings
- Operating Modes
- Software Installation
- Set the Connection Mode
- Shortcuts
- Establish a Connection with the Detector
- Configure the Detector
- Correction and Calibration Template Generation
- Image Check and Upload
- Defect Template Check and Modification
- Correction and Calibration Management
- Update the Firmware
- Publication History
Correction and Calibration Template Generation
Correction and calibration should be performed after installation and every six months.
The new correction and calibration should be performed after any major change on
the system settings and hardware conguration.
Safety and Regulatory Information
AJ4312 | 2020-02-10 1-23