User's Manual

Country Item
European Union
ETSI EN 300 328 V2.1.1
ETSI EN 301 893 V2.1.1
ETSI EN 300 440 V2.1.1
ETSI EN 301 489-3 V2.1.1
Draft ETSI EN 301 489-1 V2.2.1
Draft ETSI EN 301 489-17 V3.2.0
EN 55032: 2015
EN 55035: 2017
EN 61000-3-2: 2014
EN 61000-3-3: 2013
EN 50566: 2017
EN 62209-2: 2010
EN 62479: 2010
FCC Compliance
• The panel has been tested to comply with limits for a Class B digital device,
pursuant to part 15 of FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
• Operation is subject to the following two conditions.
The panel may not cause harmful interference.
The panel must accept any interference received, including interference that may
cause undesired operation.
• The panel generates, uses, and radiates radio frequency energy and, if not installed
and used in accordance with the instruction, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If the panel does cause harmful interference to
radio or television reception, which can be determined by turning the panel off and
on, the user is encouraged to correct the interference by one or more of the
following measure.
• Reorient or relocate the antenna.
• Increase the separation between the panel and receiver.
• Connect the panel into an outlet different from the receiver is connected.
• Consult the distributor or an experienced radio/TV technician for help.
Safety and Regulatory Information
1-22 AJ4312 | 2020-02-10