User's Manual
Table Of Contents
- Contents
- Notices and Conventions
- 1 Safety and Regulatory Information
- 2 Overview
- 3 Installation
- 4 Operation
- Appendix (For Service Personnel Only)
- Software and Settings
- Operating Modes
- Software Installation
- Set the Connection Mode
- Shortcuts
- Establish a Connection with the Detector
- Configure the Detector
- Correction and Calibration Template Generation
- Image Check and Upload
- Defect Template Check and Modification
- Correction and Calibration Management
- Update the Firmware
- Publication History
Maintenance and Inspection
Maintenance and
Inspection
WARNING:
• Turn off the power of the product and disconnect the power cord of the
adapter before cleaning.
• Never use alcohol, ether, and other ammable cleaning agent for safety.
Never use methanol, benzene, and acid to avoid corrosion on the
equipment.
• Do not place the product in liquid.
WARNING:
Make sure that the surface and connectors are dry before turning on the
product to avoid re or electric shock.
WARNING:
Clean the power cord connector periodically. Disconnect the connector from
the AC outlet. Use a dry cloth to remove dust or dirt from the connector, its
periphery, and the AC outlet.
If the cord is kept plugged in for a long time in a dusty, humid, or sooty
place, dust around the plug will attract moisture; this could cause insulation
failure that may result in a re.
WARNING:
For safety reasons, be sure to turn off the power when performing the
inspections indicated in this manual to avoid electrical shock.
When a Problem Occurs
When a Problem Occurs
WARNING:
If any one of the following occurs, immediately disconnect the power cord
of the adapter or battery, and contact your sales representative or local
dealer:
• When there is smoke, an odd odor, or abnormal sound
• When liquid has spilled into the equipment or a metal object has entered
through an opening
• When the product has been dropped and damaged
Safety and Regulatory Information
AJ4312 | 2020-02-10 1-13