User's Manual
Table Of Contents
- Contents
- Notices and Conventions
- 1 Safety and Regulatory Information
- 2 Overview
- 3 Installation
- 4 Operation
- Appendix (For Service Personnel Only)
- Software and Settings
- Operating Modes
- Software Installation
- Set the Connection Mode
- Shortcuts
- Establish a Connection with the Detector
- Configure the Detector
- Correction and Calibration Template Generation
- Image Check and Upload
- Defect Template Check and Modification
- Correction and Calibration Management
- Update the Firmware
- Publication History
Handling
CAUTION:
• Do not use the product close to re or in high temperature.
• Do not invert the positive and negative poles.
• Do not allow the product to make contact with metal to avoid a short
circuit.
• Do not insert sharp objects into the battery.
• Do not strike the battery.
• Do not stand on the battery.
• Do not use the battery outside of the guidelines.
• Do not dispose of the battery or change the inner structure.
• Do not submerge the battery in water. When in use, do not allow the
battery to have contact with water. Store the battery in a dry place.
• Use a charger to charge the battery following the GB 9706.1 Standards
provided.
• Do not replace the battery provided with one from another company.
• Do not use a damaged charger to charge the battery.
• Only qualied personnel may replace the battery inside the main unit.
• Do not touch the output connector for the adapter.
• Do not remove the battery when the detector is powered on only with
the battery.
• Replace the DC power cable if either of the following occurs:
• An arc occurs at the detector interface when connecting the cable
• The power indicator is not illuminated after connecting the cable
Safety and Regulatory Information
1-12 AJ4312 | 2020-02-10