User's Manual
Table Of Contents
- Contents
- Notices and Conventions
- 1 Safety and Regulatory Information
- 2 Overview
- 3 Installation
- 4 Operation
- Appendix (For Service Personnel Only)
- Software and Settings
- Operating Modes
- Software Installation
- Set the Connection Mode
- Shortcuts
- Establish a Connection with the Detector
- Configure the Detector
- Correction and Calibration Template Generation
- Image Check and Upload
- Defect Template Check and Modification
- Correction and Calibration Management
- Update the Firmware
- Publication History
Cautions
Environment for Installation and Use
Environment for
Installation and Use
WARNING:
Do not use or store the product near ammable chemicals such as alcohol,
thinner, benzene, etc.
Chemicals that are spilled or evaporated may result in re or electric shock
through contact with electric parts inside the product. Also, some
disinfectants are ammable. Be sure to take care when using them.
WARNING:
Do not connect the equipment with anything other than the specied
connectors to avoid re or electric shock.
WARNING:
Keep all patients with active implantable medical devices away from the
product.
Installation and
Environment of Use
CAUTION:
Do not install the product in any of the locations listed below to avoid
failure, malfunction, falling, re, or injury.
• Close to facilities where water is used
• Where there is exposure to direct sunlight
• Close to the air outlet of an air conditioner or ventilation equipment
• Close to a heat source such as a heater
• Where the power supply is unstable
• In a dusty environment
• In a saline or sulfurous environment
• Where temperature or humidity is high
• Where there is freezing or condensation
• In areas prone to vibration
• On an incline or in an unstable area
Safety and Regulatory Information
1-4 AJ4312 | 2020-02-10