User's Manual

Mars1717VS Digital Flat Panel Detector User Manual
12 iRay Technology Co., Ltd..
CAUTION
Installation and
environment of
use
 Do not install the equipment in any of the locations
listed below. Doing so may result in failure,
malfunction, equipment falling, fire or injury.
Close to facilities where water is used
Where it will be exposed to direct sunlight
Close to the air outlet of an air-conditioner or ventilation
equipment
Close to heat source such as a heater
Where the power supply is unstable
In a dusty environment
In a saline or sulfurous environment
Where temperature or humidity is high
Where there is freezing or condensation
In areas prone to vibration
On an incline or in an unstable area
 Take care that cables do not become tangled during
use. Also, be careful not to get your feet caught by
cable.
Otherwise, it may cause a malfunction of the equipment or
injury of the user due to tripping over the cable.
Power supply
 Always connect the three-core power cord plug to a
grounded AC power outlet.
 To make it easy to disconnect the plug at any time,
avoid putting any obstacles near the outlet. Otherwise,
it may not be possible to disconnect the plug in an
emergency.
 Be sure to ground the equipment to an indoor
grounded connector. Also, be sure to connect all the
grounds for the system to a common ground.
 Do not use any power source other than the one
provided with this equipment.
Otherwise, fire or electric shock may be caused due to
leakage.
Handling
 Do not spill liquid or chemicals onto the equipment. In
case the patient is injured, it is not allowed to contact
with blood or other body fluids.
Doing so may result in fire or electric shock.
In such a situation, protect the equipment with a disposable
cover as necessary.
 Turn OFF the power and pull out the plug to each piece
of equipment for safety when not used.