User's Manual Part 2

7-32
3. Select “Trace Delay”
4. Select desired delay
5. Touch Back button to close the menu
7.2.4. Auto Strip
Auto strip allows the automatic report feature of the recorder to be switched ON and OFF. The
auto strip will automatically print when a clinical alarm is detected.
To enable the Auto Strip follow these steps:
1. Press the SETTINGS button
2. Select “Recorder Setup”
3. Toggle “Auto Strip” ON and OFF
4. Touch Back button to close the menu
7.2.5. Run Time
Recorder Run Time allows users to adjust the length of time the recorder prints when activated.
The options are 8, 12, 16, 20 and 30 seconds.
To adjust the waveform Record Run Time follow these steps:
1. Press the SETTINGS button
2. Select” Recorder Setup”
3. Select “Run Time“
4. Select desired time
5. Touch Back button to close the menu
7.2.6. Recorder Sweep Speed
The Sweep Speed switches the recorder speed between 25 and 50 mm/second.
To adjust recorder Sweep Speed follow these steps:
1. Press the SETTINGS button
2. Select “Recorder Setup”
3. Select “Speed”
4. Select desired speed
5. Touch Back button to close the menu
7.2.7. To manually start a strip chart recording
Press the front panel “Record” hard key at either the 3880 Monitor or 3885-T Remote Tablet.
7.2.8. Recorder Output
The strip chart recorder output will be the waveform Trace or Traces selected in the Record
Setup along with the selected delay and run time, with the text printout of all active vital signs
values. The vital signs, such as HR, SpO2, Blood Pressure, GAS measurements, and
Temperature print on the paper in a table at conclusion of the strip run time.
7.3. Printing