User's Manual Part 3

10-9
Gas System Inop
Hardware or software failure detected in a gas measurement system
Med
Gas System Warmup
CO2/Multi-Gas unit warming up
N/A
LAN Conn Error
LAN connection errors preventing communication
Low
Low ECG Batt
≤ 15% of battery capacity left in ePOD
Low
Low Mon Batt
≤ 15% of battery capacity left in 3880 monitor
Low
Low SpO2 Batt
≤ 15% of battery capacity left in oPOD
Low
Low Sig IQ
SpO2 unit reports Signal IQ Low
Low
Low Tab Batt
≤ 15% of battery capacity left in 3885-T Remote Tablet
Low
Low Perfusion
Low perfusion detected by SpO2
Low
Mag Field High
Agent bench magnetic field limitations surpassed
Med
Multi Agent MAC
The MAC value consists of more than one agent
Med
Mixed Agents
More than two agents may be present
Med
NIBP Cal Error
Calibration error detected
Med
NIBP Delayed
NIBP reading start held for blood flow
N/A
NIBP Inop
Hardware or software failure detected
Med
NIBP Leak
Air leak is detected
Low
NIBP Occlusion
Occlusion is detected
Med
NIBP Over Press
Pressure exceeds 300 mmHg for Adult / Ped or 150 mmHg for Neonatal
patients
-or-
15 mmHg remains in the line for Adult / Ped or 5mmHg for Neo for
greater than 90 seconds
Low
NIBP Time Out
Pressure remains the same for more than 30 seconds or if
measurement exceeds 180 seconds
Low
No Sample Line
CO
2
sampling line disconnected, 3886 Only
Low
Out of Paper
Recorder paper has run out at Base
Low
POST Fail
Power on self-test failure
Med
Recorder Inop
Hardware or software failure detected in Base recorder
Low
Recorder Off Line
Print head is too hot or communication loss to the recorder/Base
Low
Radio Inop
Radio failure detected with comm to 3885 Base/Tablet
Med
SEE MESSAGES!
Critical message area full
High
Sp02 Batt Crit
Battery level in SpO2 transmitter POD at extreme low level
High
SpO2 Noisy
SpO2 unit reports noisy signals from sensor
Low
SpO2 Hi Light
SpO2 unit reports high ambient light at sensor
Low
SpO2 Bad Probe
SpO
2
sensor damaged or not compatible
Low
SpO2 Inop
Hardware or software failure detected
Med
SpO2 No Probe
SpO
2
sensor is disconnected from the oPOD
N/A
SpO2 Probe Off
SpO
2
sensor is not properly attached to the patient
Med
SpO2 Searching
Searching for patient pulse
N/A
SW Mismatch
Software version difference between 3880 components
Low
Temp Inop
Hardware or software failure detected
Med
Temp Probe Fail
Broken sensor detected or a sensor is not attached properly
Low
Wrong Cuff
NIBP system detects an incorrect cuff size for the selected patient mode
Low
All vital signs with alarm limits use high priority indication for violations.
Priority is indicated with visual and audible indications:
Low – Blue, Medium – Yellow, High – Red. See section 4.1.4